top of page




SkyFighter V2 RC Model Designed by: Frank Petty
This RC model is an original design by Frank. This model was intended to be a fast, agile flyer and certainly is. The original RC model design was made with 1.9, 15mm EPP and covered with fiberglass weave and colored sealing/packing tape. Other materials such 1/2 inch Bluecore Foam may be used to make this model.



  • Wing Span: 23.5 Inches (59.69cm)

  • Length: 30 Inches (71.12cm)

  • AUW: 24 Ounces (680.4gm) (As Built with EPP Foam, Bluecore Foam will result in much lighter model)

  • Servos: 2 Micro (Metal Gear Recommended)

  • Motor: 2212/6 for Basic Setup (Grayson Hobbies Super Mega Jet for Performance Setup)

  • Speed: 90+mph (144kph) depending on motor used

  • Required Radio: Minimum 4-Channel (Recommended 6 channel 2.4ghz)

  • Flight Skill Required: Intermediate to Advanced

  • Building Skill Required: Intermediate

Free PDF Plan Below:

bottom of page